— 7 —
3. Removing of the sensor
A. Remove the screw and the holder. B. Remove the 2 screws and decorative piece.
C. Remove the 3 screws and sensor D. Remove the O-ring and sensor.
plate/protection.
O-ring
Sensor
4. Removing of the antenna
A. Follow the instruction “Removing of the
module from the case” and remove the module.
B. Remove the Reinforcement Plate that is fit
in the center. (Obtain a Cushion to place
around the antenna in a separated order.)
Never replace the sensor, the antenna or the PCB ass'y alone.
Because the matching of the sensor and antenna has been adjusted in the factory production line.
To Next Page
Loading...
Need help?
General
