Casio SE-G1 Quick Programming Guide

Load Memory Protection Batteries and Paper Roll
D) Install the supplied thermal paper roll by lifting up the
platen arm and placing the paper roll into the printer well as
shown below. Close the cover firmly.
1
Initialize Your Cash Register
2
A)
Insert the supplied key and turn
to the “OFF” position.
B) Plug the power cord into the AC outlet and wait for
the instructional messages to print.
IMPORTANT: Confirm that the plus (+) and minus (-
) ends of the batteries
are facing in the directions indicated in the illustration inside the
battery compartment.
To prevent losing all of your settings and sales
data, we recommend you install the two memory
protection batteries.
Choosing the Language
3
A)
For English select the following:
Please also refer to printout instructions from the cash register
To set for
Receipt printing
:
To set for
Journal printing
:
A) Turn key to the PGM position
B) Perform steps as follows:
Setting Date and Time
4
A)
Input date and time as indicated on the printout chit on the cash
register
6
A) Turn key to the
Z position
B) Perform the following sequence
Note: This operation automatically sets correct tax
rates, rounding, and receipt formats to Australian
standards.
Setting for Australian Standards
6
6
A) Turn key to the PGM position
B) Press
To enable
C) Press
then press departments as required
D) Press
If using shift departments
otherwise skip this step
To disable use same sequence except use in place of
Casio SE-G1 Australian Quick Programming Guide
(please also refer to the “User Manual” supplied for further information if required)
“
A) Turn key to the PGM position
B) Perform steps as follows:
1
Load Memory Protection Batteries and Paper Roll
Printer switch for receipt or journal
5
A) Remove the printer cover
B) Open Battery
Compartment
cover
C) Insert 2 new “AA” type batteries
into the compartment
Setting GST to Departments
7

Casio SE-G1 Specifications

General

Clerk lock	Yes
Memory type	Flash ROM
Number of users	8 user(s)
Keyboard number of keys	34
Supported paper width	58 mm
Backlight	No
Display digits	8 digits
Display number of lines	1 lines
Second display number of characters	8
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %
Power source	AC
Power consumption	100 mA

Weight and Dimensions

Depth	345 mm
Width	326 mm
Height	167 mm
Weight	3500 g