GETTING STARTED
PROGRAM
To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:
• Install Keyless Entry Control within sight of garage door, out of reach of small children at a
minimum height of 5 feet (1.5 m) above floors, landings, steps or any other adjacent walking
surface, and away from ALL moving parts of door.
• ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or
play with remote controls.
• Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are no
obstructions to door travel.
• ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to
cross path of moving gate or door.
To program the Keyless Entry to more than one garage door
opener, repeat the programming steps using a new PIN for each
additional garage door opener.
For additional programming instructions or additional help
please visit www.chamberlain.com/114A5071.pdf
WIRELESS KEYLESS ENTRY
MODELS 940EV, 940EV-P2, 940EVC AND 940EVC-P2
For use with Chamberlain garage door openers manufactured after January 1, 1993. The garage
door opener activates when the 4-digit Personal Identification Number (PIN) and ENTER button are
pressed on the Keyless Entry.
Install the battery and program the Keyless Entry prior to installation. Make sure the garage
door opener has a working light bulb because it is a programming indicator.
Para Manual en Español ir a:
www.chamberlain.com/CatalogResourcesV3/en-us/shared/files/tucmanuals/114A5044SP.pdf
WARNING: This product can expose you to chemicals including lead, which are known
to the State of California to cause cancer or birth defects or other reproductive harm. For
more information go to www.P65Warnings.ca.gov
Learn
LED
Learn
LED
OR OR
Learn
LED
Green or
Red/Orange
Purple
Yellow
Locate the Learn button on the garage door opener. NOTE: Your garage door opener may look
different.
Press and hold the * and #
buttons until the lights on the
keypad stop blinking.
GARAGE DOOR OPENER TYPE # OF PRESSES
Yellow Learn Button (315 and 390 MHz Security+ 2.0
®
)1
Purple Learn Button (315 MHz Security+
®
)2
Red/Orange Learn Button (390 MHz Security+
®
)3
Green Learn Button (390 MHz Billion Code) 4
Enter a 4-digit personal
identification number (PIN) of
your choice, then press the
ENTER button.
Press and release the ENTER button on the Keyless Entry the
number of times that corresponds with your garage door
opener type:
Press and release the 0
button.
Press and release the Learn
button on the garage door
opener. The Learn LED will light.
Within 30 seconds...
Enter your 4-digit PIN, then press and release the ENTER
button until the garage door opener lights flash or two clicks
are heard.
Click
Click
To test, enter your PIN, then press the ENTER button. The
garage door opener will activate.
1
2
3
4
5
6
7
To Next Page
Need help?
General
