2
Antenna
ON
OFF
1
2
SWITCH SETTINGS
Switch #1
Switch #2
Learn Button
OFF Low Sensitivity
ON High Sensitivity (Default)
OFF 15 Feet (4.5 m) Detection Range
ON 30 Feet (9.1 m) Detection Range
(Default)
NOTE: To avoid detection of small animals move Switch #2
to OFF.
Assembly and Programming
Attach Motion Sensor box to
mounting plate with large silver
screw. Tighten screw until
Motion Sensor stays in place
when repositioned.
Install 4 AA Alkaline
batteries. (Lithium batteries
recommended for colder
environments.)
LED light will flash.
Plug in the Base Station.
Adhere rubber pads to the
bottom of the base.
4 AA batteries are optional in
case of a power failure.
OPTIONAL
DC Adapter Input
A Ensure Base Station and
Motion Sensor are in close
proximity to each other.
Press and release Learn
Button on Base Station.
Buzzer will sound.
B Within 60 seconds, press the
Learn Button on the inside
of the Motion Sensor. LED
light will illuminate and Base
Station will buzz.
Learn Button
1
2
Motion Sensor
SWITCH #1:
SWITCH #2:
3
4
Learn Button
Insert battery pack facing away
from circuit board and fasten
cover with the smallest screws
(provided).
NOTE: Ensure the batteries do
not touch the circuit board and
the antenna and battery wires
are not pinched.
5
6
MOTION SENSOR INSTALLATION
Mount Motion Sensor
horizontally on solid surface
3-5 feet (1-1.5 m) off the
ground and within 1/2 mile
(0.8 km) of Base Station (rotate
sensor to access screw holes).
Unit should be able to swivel as
needed.
Attach sun/rain shield.
NOTE: Keep Motion Sensor
antenna away from metal
objects. Do not mount Motion
Sensor in direct sunlight, near
moving tree branches, or in the
path of a sprinkler system.
4 feet (1.2 m)
10-20 feet (3-6 m)
Vehicle Alert Installation: For cars, the best mounting
position is about 4 feet (1.2 m) high, between 10-20 feet
(3-6 m) back, and angled to see the back of car after passing
the sensor.
7
Test Motion Sensor by waving
hand in front of sensor. LED
light should flash and the Base
Station will buzz X number of
times indicating which sensor
has been activated.
To Next Page
Loading...
Need help?
General
