12. Tighten the nuts firmly
in a crisscross
sequence as shown by
turning the wheel
wrench clockwise.
When you reinstall the full-size wheel and tire, you must
also reinstall the either the center cap or the bolt-on
hub cap, depending on what your vehicle has.
• If you are reinstalling a center cap, line up the tab
on the center cap with the slot on the wheel. The
cap only goes in one way. Place the cap on
the wheel and press until it snaps into place.
• If you are reinstalling bolt-on hub caps, line
up the plastic nut caps with the wheel nuts
and tighten them clockwise by hand to get them
started. Continue tightening with the wheel wrench
until snug.
5-91
To Next Page
Loading...
Need help?
General
