1
Cisco 2000 Series Hardware Installation
Cisco 2000 Series Hardware Installation
Following is the information required to install the router chassis.
About This Guide
Follow this procedural path to install your router:
1 Install the router hardware using the procedures described in this publication.
2 After the hardware is installed, refer the Router Products Getting Started Guide or
to the appropriate software publication to configure the router.
3 Refer to the “Reference” section in this publication for cabling and basic
troubleshooting information.
Installation
This section guides you through the installation of the router and includes information
on safety, inspecting the system, preventing electrostatic discharge (ESD) damage,
tools and parts required, rack mounting, wall mounting, and making external cable
connections.
Note If you have questions about agency approvals, basic troubleshooting, system
specifications, or specific cable pinout information, review the information in the
section “Reference” on page 9.
Safety Recommendations
Follow these guidelines to ensure general safety:
• Keep the router area clear and dust-free during and after installation.
• Put the removed router cover in a safe place.
• Keep tools away from walk areas where you and others could trip over them.
• Do not wear loose clothing that could get caught in the router chassis. Fasten your
tie or scarf and sleeves.
• Wear safety glasses when working under any conditions that might be hazardous to
your eyes.
• Do not perform any action that creates a potential hazard to people or makes the
equipment unsafe.
To Next Page
Need help?
General
