Prepare for Installation
Before you install the router, you must prepare your site for installation.
Preparing your site involves the following tasks:
• General Precautions, on page 1
• Site Planning Checklist, on page 2
• Environmental Requirements, on page 2
• Airflow Guidelines, on page 2
• Site Power Guidelines, on page 4
• Site Cabling Guidelines, on page 5
• Tools and Equipment, on page 6
• Prepare Your Location , on page 7
• Prepare Yourself , on page 7
• Prepare Rack for Router Installation, on page 8
• Cabinet Selection Guidelines, on page 8
• Unpack the Cisco 8011 Router, on page 9
General Precautions
Observe the following general precautions when using and working with your router:
• Keep your system components away from radiators and heat sources, and do not block cooling vents.
• Do not spill food or liquids on your system components, and never operate the product in a wet
environment.
• Do not push any objects into the openings of your system components. Doing so can cause fire or electric
shock by shorting out interior components.
• Position system cables and power supply cable carefully. Route system cables, the power supply cable,
and plug so that they are not stepped on or tripped over. Be sure that nothing else rests on your system
component cables or power cable.
• Do not modify power cables or plugs. Consult a licensed electrician or your power company for site
modifications. Always follow your local and national wiring rules.
• If you turn off your system, wait at least 30 seconds before turning it on again to avoid damage to the
system components.
Prepare for Installation
1
To Next Page
Need help?
General
