Cisco ASA 5540 User Manual

1-10
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring Objects
Configuring Objects
Configuring an ICMP Group
An ICMP group includes multiple ICMP types.
Detailed Steps
Example
Create an ICMP type group that includes echo-reply and echo (for controlling ping) by entering the
following commands:
hostname (config)# object-group icmp-type ping
hostname (config-service)# description Ping Group
hostname (config-service)# icmp-object echo
hostname (config-service)# icmp-object echo-reply
Command Purpose
Step 1
object-group icmp-type grp_id
Example:
hostname(config)# object-group icmp-type
ping
Adds an ICMP type object group. The grp_id is a text string up to
64 characters in length and can be any combination of letters,
digits, and the following characters:
• underscore “_”
• dash “-”
• period “.”
The prompt changes to ICMP type configuration mode.
Step 2
Add one or more of the following group members:
icmp-object icmp-type
Example:
hostname(config-icmp-type)# icmp-object
echo-reply
Defines the ICMP types in the group. Enter the command for each
type. For a list of ICMP types, see the“ICMP Types” section on
page 1-15.
group-object group_id
Example:
hostname(config-network)# group-object
Engineering_groups
Adds an existing object group under this object group. The nested
group must be of the same type.
Step 3
description text
Example:
hostname(config-icmp-type)# description
Ping Group
(Optional) Adds a description. The description can be up to 200
characters.

Cisco ASA 5540 Specifications

General

Firewall Throughput	650 Mbps
Maximum Firewall Connections	400, 000
VPN Throughput	225 Mbps
Maximum VPN Peers	5, 000
High Availability	Active/Active, Active/Standby
IPSec VPN Throughput	225 Mbps
Memory	1 GB
IPS Throughput	225 Mbps
Security Contexts	50
Flash Memory	64 MB
Form Factor	1U
Power Supply	Dual
Interfaces	4 x 10/100/1000 Ethernet