Cisco ASR 9006 User Manual

Figure 12: Removing or Installing a Version 2 AC or DC Power Module from the Cisco ASR 9904 Router
Installing a Version 1 AC or DC Power Module
Follow these steps to install a new version 1 AC or DC power module (Figure 10: Removing or Installing a
Version 1 AC or DC Power Module, on page 15):
Procedure
Step 1 Slide the power module into the bay until it mates with its backplane connector.
Step 2 Pivot the door to the left until the door latch locks.
To prevent damage to the power tray backplane connector, do not use excessive force when inserting
the power module into the power tray.
Caution
Step 3 Verify that the (green) Power Input indicator on the front of the power module goes on. If the indicator does
not light, see Troubleshooting the Power Subsystem .
Installing a Version 2 or Version 3 AC or DC Power Module
Follow these steps to install a new version 2 or version 3 AC or DC power module (Figure 11: Removing or
Installing a Version 2 or Version 3 AC or DC Power Module, on page 15):
Replacing Cisco ASR 9000 Series Router Components
16
Replacing Cisco ASR 9000 Series Router Components
Installing a Version 1 AC or DC Power Module

Cisco ASR 9006 Specifications

General

Brand	Cisco
Model	ASR 9006
Category	Network Router
Language	English