Cisco ASR 9010 User Manual

Figure 14: Removing the Front Power Tray Bezel on the Cisco ASR 9922 Router
Step 5 For the Cisco ASR 9912 Router, the vented power tray bezel is a base chassis accessory that snaps onto the
front of the power system. comes with ball studs already installed. Remove it by pulling it away from the
chassis (Figure 1).
Step 6 Loosen and remove the four screws (two screws at each end) that attach the power tray to the chassis.
Step 7 Loosen the two captive screws (one per ejector lever) to release the ejector levers. The Removing a Power
Tray—Version 1 Power Tray figure shows the process for the version 1 power trays, and the figure Removing
a Power Tray –Version 2 Power Tray shows the process for the version 2 power trays. The process for version
3 power trays is similar to the process for version 2 power trays, as shown in figure Removing a Power Tray
–Version 2 Power Tray .
Figure 15: Removing a Power Tray—Version 1 Power Tray (Cisco ASR 9010 Router Shown)
Replacing Cisco ASR 9000 Series Router Components
22
Replacing Cisco ASR 9000 Series Router Components
Removing an AC or DC Power Tray from a Cisco ASR 9000 Series Router

Cisco ASR 9010 Specifications

General

Brand	Cisco
Model	ASR 9010
Category	Network Router
Language	English