Step 11 Verify RSP5 in slot 1 and RSP in slot 0 reach full synchronization (NSR-ready state) and status of ALL the
groups is Ready state. Use show redundancy command to verify the same.
Example:
Router# show redundancy
Fri Jul 12 20:51:19.365 UTC
Active Node Standby Node
----------- ------------
0/RSP1/CPU0 0/RSP0/CPU0(Node Ready, NSR:Ready)
Step 12 Remove standby RSP (slot 0). Follow the procedure explained in the topic Removing and Replacing Cards
from the Chassis, on page 25.
Step 13 Insert and boot RSP5 (slot 0). After booting, the RSP5 becomes standby RSP.
Example:
Router# show platform
Node Type State Config state
--------------------------------------------------------------------------------
0/RSP0/CPU0 A9K-RSP5-TR(Standby) IOS XR RUN NSHUT
0/RSP1/CPU0 A9K-RSP5-TR(Active) IOS XR RUN NSHUT
0/FT0 ASR-9910-FAN OPERATIONAL NSHUT
0/FT1 ASR-9910-FAN OPERATIONAL NSHUT
0/1/CPU0 A9K-8X100GE-TR IOS XR RUN NSHUT
0/FC0 A99-SFC-S OPERATIONAL NSHUT
0/FC1 A99-SFC-S OPERATIONAL NSHUT
0/FC2 A99-SFC-S OPERATIONAL NSHUT
0/FC3 A99-SFC-S OPERATIONAL NSHUT
0/FC4 A99-SFC-S OPERATIONAL NSHUT
0/PT0 A9K-AC-PEM-V3 OPERATIONAL NSHUT
0/PT1 A9K-AC-PEM-V3 OPERATIONAL NSHUT
Step 14 Repeat Step 6, Step 7 and Step 8.
Step 15 (Optional) Perform FPD upgrade on the RSP5. Use these commands:
An FPD upgrade can be performed after all the FCs/LCs are added to the system.
Note
Example:
sysadmin-vm:0_RSP1# upgrade hw-module location 0/RSP0 fpd
sysadmin-vm:0_RSP1# upgrade hw-module location 0/RSP1 fpd
Step 16 Reload the system once FPDs are upgraded using the admin hw-module location all reload command.
Replacing Cisco ASR 9000 Series Router Components
40
Replacing Cisco ASR 9000 Series Router Components
Migrating from RSP4/RSP4-S/RSP-L to RSP5 Card
To Next Page
Loading...
Need help?
General
