Cisco ASR 907 Installing

Installing the Cisco ASR 907 Router
This chapter describes how to install the Cisco ASR 907 Router and includes the following sections:
• Prerequisites, on page 1
• Installing the Router in a Rack, on page 1
• Installing the Chassis Ground Connection, on page 12
• Installing the Fan Tray, on page 15
• RSP Installation, on page 20
• Installing the Interface Module Carrier, on page 24
• Interface Module Installation, on page 24
• Installing the Power Supply, on page 28
• Connecting the Cisco ASR 907 Router to the Network, on page 39
Prerequisites
Before installing the Cisco ASR 907 Router, it is important to prepare for the installation by:
• Preparing the site (site planning) and reviewing the installation plans or method of procedures (MOP)
• Unpacking and inspecting the Cisco ASR 907 Router
• Gathering the tools and test equipment required to properly install the Cisco ASR 907 Router
For more instructions on how to prepare for the installation of the Cisco ASR 907 Router, see Preparing for
Installation.
Installing the Router in a Rack
The following sections describe how to install the Cisco ASR 907 Router in a rack:
Installing the Chassis Brackets
The chassis is shipped with mounting brackets that can be installed on the front or rear of the chassis. To
install the brackets on the front of the chassis, perform these steps:
Installing the Cisco ASR 907 Router
1

Cisco ASR 907 Specifications

General

Brand	Cisco
Model	ASR 907
Category	Network Router
Language	English