Installing the Cisco ASR-920-10SZ-PD Router
This chapter describes how to install the Cisco ASR-920-10SZ-PD Router and includes the following sections:
•
Prerequisites, page 1
•
Installing the Router in a Rack, page 1
•
Connecting the Chassis Ground and Power, page 5
•
Power Connection Guidelines, page 8
•
Assembling and Connecting the DC Power Cable to the Router, page 10
•
Installing and Removing SFP Modules, page 12
•
Connecting to the 10/100/1000 Ports, page 16
•
Connecting a Cisco ASR-920-10SZ-PD Router to the Network, page 18
Prerequisites
Before installing the Cisco ASR-920-10SZ-PD Router, it is important to prepare for the installation by:
•
Preparing the site (site planning) and reviewing the installation plans or method of procedures (MOP).
See Site Planning section.
•
Unpacking and inspecting the Cisco ASR-920-10SZ-PD Router. See Unpacking and Verifying the
Shipped Contents section.
•
Gathering the tools and test equipment required to properly install the Cisco ASR-920-10SZ-PD Router.
See Tools and Equipment section.
For more instructions on how to prepare for the installation of the Cisco ASR-920-10SZ-PD Router, see
Preparing for Installation.
Installing the Router in a Rack
The following sections describe how to install the Cisco ASR-920-10SZ-PD Router in a rack. The procedures
in this section apply to both horizontal and vertical mounting of the router in a rack:
Cisco ASR 920-10SZ-PD Aggregation Services Router Hardware Installation Guide
1
To Next Page
Need help?
General
