perform redundancy switchover from RSP0 to RSP1, and make RSP1 as active RSP.
Step 2 Remove the standby RSP440 (RSP0) and insert RSP880 in slot 0. Follow the procedure explained in the topic
Removing and Replacing Cards from the Chassis, on page 25.
Step 3 Connect to RSP880 console port and type CTRL+C to break into ROMMON.
Step 4 From the ROMMON prompt, set ROMMON variable to activate 1GE mode for peer RSP communication.
Example:
ROMMON prompt on RSP880 (A)
rommon B1> RSP_LINK_1G=1
rommon B1> sync
Example:
ROMMON prompt on RSP880-LT
rommon B1> RSP_LINK_1G=1
rommon B1> ALDRIN_VERSION_DISABLE=1
rommon B1> RSP4L_ALDRIN_1G=1
rommon B1> sync
Step 5 Verify that config register is set correctly in ROMMON.
Example:
rommon B1> confreg
Step 6 Reset RSP880 card. Now the RSP880 becomes the standby RSP in slot 0 and synchronizes configuration
from active RSP440 in slot 1.
Example:
rommon B1> reset –h
The RSP880 reloads and the user is disconnected from ROMMON automatically.
Note
Step 7 Wait until standby node reaches NSR-ready state and status of ALL the groups is Ready state. Use show
redundancy command to verify the same.
Example:
Router# show redundancy
Tue Nov 18 07:51:47.098 EDT
Redundancy information for node 0/RSP0/CPU0:
==========================================
Node 0/RSP1/CPU0 is in ACTIVE role
Node Redundancy Partner (0/RSP0/CPU0) is in STANDBY role
Standby node in 0/RSP0/CPU0 is ready
Standby node in 0/RSP0/CPU0 is NSR- ready
Node 0/RSP1/CPU0 is in process group PRIMARY role
Process Redundancy Partner (0/RSP0/CPU0) is in BACKUP role
Backup node in 0/RSP0/CPU0 is ready
Replacing Cisco ASR 9000 Series Router Components
34
Replacing Cisco ASR 9000 Series Router Components
Migrating from RSP440 to RSP880 or RSP880-LT Card
To Next Page
Loading...
Need help?
General
