Installing the Controller
This chapter provides procedures for installing the Cisco Catalyst 9800-40 Wireless Controller on an equipment
shelf, tabletop, or in an equipment rack.
• Installation Methods, on page 1
• Guidelines for a Standalone Equipment Shelf or Tabletop Installation, on page 2
• Installing the Controller on a Standalone Equipment Shelf or Tabletop, on page 2
• Guidelines for Rack Installation, on page 3
• Attaching Front Rack-Mount Brackets, on page 4
• Attaching Rear Rack-Mount Brackets, on page 5
• Mounting the Controller in the Rack, on page 6
• Attaching the Cable Management Bracket, on page 10
• Chassis Ground Connection, on page 12
• Connecting Cables, on page 14
• Management Ethernet Port Cable Connection, on page 15
Installation Methods
The Cisco Catalyst 9800-40 Wireless Controller s are designed for standalone, 2-rail 19-inch rack-mount
(front rail only), and 4-rail 19-inch rack-mount (front and rear rail) installations.
Although rack-mounting is the preferred method of installation, you can mount the chassis on an equipment
shelf or tabletop.
Read the installation instructions before using, installing or connecting the system to the power source.
Statement 1004
Warning
Proceed with the installation, if you have already unpacked your chassis and read all the site requirements for
your new equipment.
Note
Installing the Controller
1
To Next Page
Need help?
General
