Cisco CRS Manual

Removing the Front (SFC) Side Cosmetic Components
This section describes how to remove the front (SFC) side exterior cosmetic components, shown in Figure 1:
FCC Front (SFC) Side Exterior Cosmetic Components—Fixed Configuration Power Shown, on page 2,
from the chassis. This section includes all the steps for you to remove all the front cosmetic parts from the
chassis, but you are not required to do so. To remove a particular part, see the appropriate step or steps in the
procedure that follows.
While it is possible to remove most of the front cosmetic components on the FCC separately, some parts
(such as a unistrut) require that other parts be removed first.
Note
This section describes how to perform the following tasks:
Prerequisites
No prerequisites exist for this task.
Required Tools and Equipment
You need the following tools to perform this task:
• 8-in. long number 1 Phillips screwdriver—magnetic head preferable
•
10-mm hex key wrench
Steps
To remove the front (SFC) side external cosmetic components, perform the following steps:
Cisco CRS Carrier Routing System Fabric Card Chassis Installation Guide
15
Installing and Removing Exterior Cosmetic Components
Removing the Front (SFC) Side Cosmetic Components

Cisco CRS Specifications

General

Brand	Cisco
Model	CRS
Category	Network Router
Language	English