Maintenance and Upgrade
• Install the Network Module, on page 1
• Remove and Replace the Fan Module, on page 4
• Remove and Replace the SSD, on page 5
• Remove and Replace the Power Supply Module, on page 8
• Connect the DC Power Supply Module, on page 10
• Secure the Power Cord on the AC Power Supply Module, on page 16
Install the Network Module
Take note of the following warnings:
Statement 60—UL- and CSA-Certified Equipment Warning
This card is intended to be installed in UL- and CSA-certified equipment in the field by the user in the
manufacturer's defined operator access area. Check the equipment manufacturer to verify/confirm that your
equipment is suitable for user-installed application cards.
Warning
Statement 1029—Blank Faceplates and Cover Panels
Blank faceplates and cover panels serve three important functions: they prevent exposure to hazardous voltages
and currents inside the chassis; they contain electromagnetic interference (EMI) that might disrupt other
equipment; and they direct the flow of cooling air through the chassis. Do not operate the system unless all
cards, faceplates, front covers, and rear covers are in place.
Warning
Statement 1030—Equipment Installation
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Maintenance and Upgrade
1
To Next Page
Need help?
General