Cisco Headset 561 and Cisco Headset 562 with Standard Base
For Cisco Jabber
Quick Reference Guide
Headset LED status indication
Incoming Call Blinking red
Active Call Steady red
Headset paired with dock White LED blinking every 4 seconds
Headset and dock not paired White LED blinking rapidly
High Sound Pressure—Avoid listening to high volume levels for long periods to prevent
possible hearing damage.
When you plug in your headset, lower the volume of the headset speaker before you put
the headset on. If you remember to lower the volume before you take the headset o, the
volume will start lower when you plug in your headset again.
Be aware of your surroundings. When you use your headset, it may block out important
external sounds, particularly in emergencies or in noisy environments. Don’t use the
headset while driving. Don’t leave your headset or headset cables in an area where
people or pets can trip over them. Always supervise children who are near your headset
or headset cables.
Call Indication
Incoming call Blinking green
Active call Steady green
Muted call Steady red
Power/Call
Mute
Volume +/-
Base LED status indication
Battery strength LEDs show solid as battery charges
System updating LEDs blink in sequence from left to right
Headset and dock not paired All LEDs blinking
To Next Page
Need help?
General
