Installing the Cisco MDS 9700 Series Switches
This chapter describes how to install the Cisco MDS 9700 Series Multilayer Director switches and its
components. This chapter includes the following topics:
• Preparing for Installation, on page 1
• Attaching Bottom-Support Rails to a Two-Post Rack, on page 5
• Attaching Bottom-Support Rails to a Four-Post Rack, on page 6
• System Grounding, on page 25
Preparing for Installation
Before you install, operate, or service the system, read the Regulatory Compliance and Safety Information
for the Cisco MDS 9000 Family for important safety information.
Note
This warning symbol indicates danger. You are in a situation that could cause physical injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard
practices for preventing accidents. Use the statement number provided at the end of each warning to locate
its translation in the translated safety warnings that accompanied this device. Statement 1071
SAVE THESE INSTRUCTIONS
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be accessed only
through the use of a special tool, lock and key, or other means of security. Statement 1017
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030
Warning
Installing the Cisco MDS 9700 Series Switches
1
To Next Page
Need help?
General