10 Cisco 350XG Series 1OG Stackable Switches Quick Start Guide
SFP+ Port(if present)—The small form-factor pluggable plus (SFP+) are
connection points for modules so that the switch can link to other switches.
These ports are also commonly referred to as mini 10GigaBit Interface
Converter ports. The term SFP+ will be used in this guide.
• The SFP+ ports are compatible with Cisco modules MGBSX1, MGBLH1,
MGBT1, MGBLX1, MGBBX1, as well as other brands of modules.
• The Cisco SFP+ 10G optical modules that are supported in the Cisco
350XG switches are: SFP-10G-SR, SFP-10G-LRM, and SFP-10G-LR.
• The Cisco SFP+ Copper Cable modules for stacking that are supported
in the Cisco 350XG switches are: SFP-H10GB-CU1M, SFP-H10GB-
CU3M, and SFP-H10GB-CU5M.
• The SFP+ port is a combination port, shared with one other RJ-45 port.
When the SFP+ is active, the adjacent RJ-45 port is disabled.
• The LEDs of the shared RJ-45 port light to respond to the SFP+ port
traffic.
OOB+Port—The Out of Band (OOB) port is a CPU's Ethernet port that can
be used only as a management interface. Bridging between the OOB port
and the in-band Layer 2 interface is not supported.
Front Panel LEDs
Master—(Green) Lights steady when the switch is a stack master.
System—(Green) Lights steady when the switch is powered on, and
flashes when booting, performing self-tests, or acquiring an IP address. If
the LED flashes Amber, the switch has detected a hardware failure, a
firmware failure, and/or a configuration file error.
Stack ID—(Green) Lights steady when the switch is stacked and the
corresponding number indicates its Stack ID.
LINK/ACT—(Green) Located on the left of each port. The light is steady
when a link between the corresponding port and another device is
detected. Flashes when the port is passing traffic.
XG—(Green) Located on the right of a 10G port. Lights steady when
another device is connected to the port, is powered on, and a 10 Gbps link
is established between the devices. When the LED is off, the connection
speed is under 10 Gbps or nothing is cabled to the port.
Gigabit—(Green) Located on the right of the OOB port. Lights steady when
another device is connected to the port, is powered on, and a
1000 Mbps link is established between the devices. When the LED is off,
the connection speed is under 1000 Mbps or nothing is cabled to the port.
To Next Page
Loading...
Need help?
General
