- TCP — Press 1 to set TCP as the transport protocol (Transmission Control Protocol).
- TLS — Press 2 to set TLS as the transport protocol (Transport Layer Security).
• Check Line 2 Transport — Press 1920 to check the actual transport protocol for SIP in
line 2.
• Set Line 2 SIP Transport — Press 1921 to set the transport protocol used in line 2 for SIP.
The options are:
- UDP — Press 0 to set UDP as the transport protocol.
- TCP — Press 1 to set TCP as the transport protocol.
- TLS — Press 2 to set TLS as the transport protocol.
• Exit IVR — Press 3948 to exit the IVR.
• Allow or prevent WAN access to the administration Web Server — Press 7932 to set
access to the administration web server:
- Enable — Press 1 to enable access.
- Disable — Press 0 to disable access.
• Factory Reset of Unit — Press 73738 to set the adapter to its factory default settings.
When prompted, press 1 to confirm, or press the Star key (*) to cancel. After you hear
"Option Successful" hang up the phone. The device reboots.
• Reboot of Voice System — Press 732668 to reboot the voice system. After you hear
"Option Successful" hang up the phone. The device reboots.
• User Factory Reset of Unit — Press 877778 to set the user settings to its factory values.
When prompted, press 1 to confirm or press the Star key (*) to cancel. After you hear
"Option Successful" hang up the phone. The device reboots.
To Previous Page
Loading...
Need help?
General
