EasyManuals Logo
Home>Cisco>Server>UCS B22 M3

Cisco UCS B22 M3 Upgrade Guide

Cisco UCS B22 M3
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
18
Cisco UCS B-Series Servers Upgrade Guide for Intel E5-2600/E5 2400 v2 Series CPUs
OL-28629-02
Cisco UCS Blade Server
Running-Vers: 8.0
Package-Vers:
Activate-Status: Ready
Step 8 Clear the WILL_BOOT_FAULT by using the Cisco UCS Manager GUI to reset the server CIMC:
a. In the Navigation pane, click the Equipment tab.
b. On the Equipment tab, expand Equipment > Chassis > Chassis number > Servers, then choose
your server.
c. In the Work pane, click the General tab.
d. In the Actions area, click Recover Server.
e. In the Recover Server dialog, click Reset CIMC (Server Controller), then click OK.
Wait for CIMC to reboot and for Cisco UCS Manager to do a shallow discovery of the server. This
takes two to three minutes. At the end of this process the WILL_BOOT_FAULT is cleared.
Note The Cisco UCS Manager 2.2(2c) bundle, including the server CIMC and BIOS, is
backward-compatible with earlier supported CPUs, so the following firmware downgrade steps
are optional.
Step 9 Optional: Downgrade your server CIMC.
Use the GUI or CLI procedures in the UCS Manager Install and Upgrade Guides.
Step 10 Optional: Downgrade your server BIOS.
Use the GUI or CLI procedures in the UCS Manager Install and Upgrade Guides.
Sample Board Controller Activation Command Sequence
The following is an example of the commands with sample values.
Box-A# scope server 1/4
Box-A /chassis/server # scope boardcontroller
Box-A /chassis/server/boardcontroller # show image
Name Type Version
--------------------------------------------- -------------------- -------
ucs-b22-m3-brdprog.3.0.gbin Board Controller 3.0
ucs-b22-m3-brdprog.8.0.gbin Board Controller 8.0
Box-A /chassis/server/boardcontroller # activate firmware 8.0 force
Warning: When committed this command will reset the end-point
Box-A /chassis/server/boardcontroller* # commit-buffer
Note The server automatically reboots after the commit-buffer command is executed.
Box-A /chassis/server/boardcontroller # show version
BoardController:
Running-Vers: 8.0
Package-Vers:
Activate-Status: Activating

Other manuals for Cisco UCS B22 M3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco UCS B22 M3 and is the answer not in the manual?

Cisco UCS B22 M3 Specifications

General IconGeneral
BrandCisco
ModelUCS B22 M3
CategoryServer
LanguageEnglish

Related product manuals