- 1 -
PN-2591M-G
Published by Service Dept.
Printed in Japan
Clarion Co., Ltd.
50 Kamitoda, Toda-shi, Saitama 335-8511 Japan
Service Dept.: 5-66 Azuma , Kitamoto-shi, Saitama 364-0007 Japan
Tel: +81-48-541-2335 / 2432 FAX: +81-48-541-2703
298-6177-00
Sep.2004
Service Manual
Model
NISSAN Automobile Genuine
FM/AM Radio CD Stereo
PN-2591M-G
(Genuine No.28185 6Z670)
(ID No.CY26A)
SPECIFICATIONS
Radio section
Tuning system: PLL frequency synthesizer system
Receive range: AM 530kHz to 1,710kHz
FM 87.75MHz,87.9 to 107.9MHz
Intermediate frequency:
AM 450+3/-3kHz
FM 10.7+0.3/-0.3MHz
Quieting sensitivity: AM Less than 32dBu(at 20dB S/N)
FM Less than 10dBu(at 30dB S/N)
Separation: FM More than 22+5/-7dB(1kHz)
S/N ratio: AM More than 45dB
FM More than 50dB
Auto tuning stop sensitivity:
AM 32+6/-6dBu
(600/1000/1400kHz)
FM 25+6/-6dBu
(87.9/98.1/107.9MHz)
CD section
Disc: 12cm Disc
Separation: More than 50dB(Filter:20kHz LPF)
S/N ratio: More than 74dB
Distortion: Less than 0.4%
(Filter:20kHz LPF)
General
Load impedance: 4 ohm/CH
Power output: 40W x 4
Power supply voltage: DC13.2V(10.8V to 16.0V)
Negative ground
Back-up consumption: Less than 3mA
Dimensions(mm): 180(W) x 52(H) x 159(D)
Weight: 1.35kg
NOTES
* We cannot supply PWB with component parts in prin-
ciple. When a circuit on PWB has failure, please repair
it by component parts base. Parts which are not men-
tioned in service manual are not supplied.
* Specifications and design are subject to change without
notice for further improvement.
COMPONENTS
PN-2591M-A,M-B,M-C
1.Main unit ----------- 1
To engineers in charge of repair or
inspection of our products.
Before repair or inspection, make sure to follow the
instructions so that customers and Engineers in
charge of repair or inspection can avoid suffering
any risk or injury.
1. Use specified parts.
The system uses parts with special safety features against
fire and voltage. Use only parts with equivalent character-
istics when replacing them.
The use of unspecified parts shall be regarded as remod-
eling for which we shall not be liable. The onus of product
liability (PL) shall not be our responsibility in cases where
an accident or failure is as a result of unspecified parts
being used.
2. Place the parts and wiring back in their original positions
after replacement or re-wiring.
To Next Page
Need help?
General
