pag 29
ELECTRONIC FILTERS (OPTIONAL)
1
Materials required for maintenance:
1. Alkaline detergent A01212 (code CLIVET C6460315)
2. Acid detergent B01212 (code CLIVET C6460316)
3. Protective gloves and goggles
4. Graduated beaker
5. Manual or pneumatic pump for spraying
2
Pour part of the alkaline detergent into the graduated
cylinder
Dilute with one part water so as to form a 50% solution
3
Fill the spray pump with the prepared solution
4
Position the filter to be washed on a support so you can
work comfortably.
Spray the detergent on the blades of the electrostatic filter
5
Also spray the detergent on the base of the contacts.
Let the detergent stand for 2-3 minutes
6
Rinse with a jet of water or with a pressurized water cleaner
at low pressure
7
Thoroughly rinse the insulators of the electrostatic cell
Turn the filter and rinse the back as well
8
After washing with alkaline detergent, this is how the filter
should look.
Otherwise repeat steps 4 to 7
To Next Page
Loading...
Need help?
General
