Craftsman 28180 - Fixed-Base Router/Table Combo User Manual

ADJUSTING THE FENCE
The fence enables you to sup-
port and guide the work piece,.
To adjust the extended fence
forward and backward (Fig, 13)
1. Loosen the two clamping
knobs (5).
2. Move the fence forward or
backward along the slots
to the desired position,
3, Tighten the clamping
knobs.The fence can be
moved forward and back-
ward 3-3/4 in.
To laterally adjust the
infeed and ouffeed fence
The infeed and outfeed fence
can each be adjusted 2 inches
in order to lengthen the fence°
1. Loosen the four wing nut&
2. Move the fence facings
right or left to the desired
position. (Fig° 14)
3. Tighten the wing nuts.
To adjust the outfeed fence
for joining (Fig. 15)
For joining operations, the
outfeed fence can be adjusted
as much as 9/16-inch forward
of the infeed fence to support
the work piece after it passes
across the router bit.
°
2_
3_
Loosen the two outfeed
fence clamping knobs.
Move the outfeed fence
forward of the infeed fence
to the width of material
you want to remove from
the work piece. Tighten
the clamping knobs.
Fig_ 13
Fig, 'I4
Fig. 15
Move and clamp the entire extended fence so that the outfeed fence is aligned
with the cutting edge of the bit.
28180 ManuaLRevised 07.0228 Page 19

Craftsman 28180 - Fixed-Base Router/Table Combo Specifications

General

Brand	Craftsman
Model	28180 - Fixed-Base Router/Table Combo
Category	Tool Storage
Language	English