Craftsman CMCCS660 User Manual

13
ENGLISH
Common Cutting Techniques (Fig. A, M–S)
Felling
The process of cutting down a tree. Be sure battery is fully
charged before felling a tree so you can finish on a single
charge. Do not fell trees in high windconditions.

WARNING: Felling can result in injury. It should only
be performed by a trainedperson.
• A retreat path should be planned and cleared as
necessary before cuts are started. The retreat path
should extend back and diagonally to the rear of the
expected line of fall (FigureM).
DIRECTION
OF
FALL
RETREAT
45°
TREE
Fig. M
45°
RETREAT
• Before felling is started, consider the natural lean of
the tree, the location of larger branches and the wind
direction to judge which way the tree will fall. Have
wedges (wood, plastic or aluminum) and a heavy mallet
handy. Remove dirt, stones, loose bark, nails, staples,
and wire from the tree where the felling cuts are to
bemade.
• Notching Undercut - Make the notch 1/3 of the
diameter of the tree, perpendicular to the direction of
the fall. Make the lower horizontal notching cut first.
This will help to avoid pinching of either the saw chain
or the guide bar when the second notch cut is being
made (FigureN).
• Felling Back Cut - Make the felling back cut at least 2"
(51mm) higher than the horizontal notching cut. Keep
the felling back cut parallel to the horizontal notching
cut. Make the felling back cut so enough wood is left
to act as a hinge. The hinge wood keeps the tree from
twisting and falling in the wrong direction. Do not cut
through the hinge (FigureN).
• As the felling cut gets close to the hinge the tree should
begin to fall. If there is any chance that the tree may
not fall in the desired direction or it may rock back and
bind the saw chain, stop cutting before the felling cut
is complete and use wedges to open the cut and drop
the tree along the desired line of fall. When the tree
begins to fall remove the chain saw from the cut, stop
the motor, put the chain saw down, then use the retreat
path planned. Be alert for overhead limbs falling and
watch yourfooting.
2" (51 mm)
DIRECTION OF FALL
2" (51 mm)
HINGE
NOTCH
FELLING BACK CUT
Fig. N
Limbing
Removing the branches from a fallen tree. When limbing,
leave larger lower limbs to support the log off the ground.
Remove the small limbs in one cut. Branches under tension
should be cut from the bottom of the branch towards the
top to avoid binding the chain saw as shown in FigureO.
Trim limbs from opposite side keeping tree stem between
you and saw. Never make cuts with saw between your legs
or straddle the limb to becut.
Fig. O
Bucking

WARNING: Recommend that first time users should
practice cutting on a sawhorse.
Cutting a felled tree or log into lengths. How you should
cut depends on how the log is supported. Use a saw horse
(FigureP) wheneverpossible.
Fig. P
1. Always start a cut with the saw chain running at
fullspeed.
2. Place the bottom spike
20
of the chain saw behind the
area of the initial cut as shown in FigureQ.
3. Turn the chain saw on then rotate the saw chain and bar
down into the tree, using the spike as ahinge.

Craftsman CMCCS660 Specifications

General

Brand	Craftsman
Model	CMCCS660
Category	Chainsaw
Language	English