HARDWARE:
_ 1/4 2o HEX NUT
,. ....
= k,IET sL SORE¢i
CASTER INSTALLATION:
NOTE: Use adequate manpower for this
operation.
• Lay the roll-away down on its back.
Use packaging material to protect the
paint finish.
• Mount both swivel casters on the
same side of the roll-away. The
swivel caster with the brake goes to
the front of the unit.
• Attach casters using 1/4-20 x 7/16
hex screws and 1/4-20 hex nuts.
Wrench tighten.
• Return the roll-away to its upright
position.
MOUNTING CHEST:
• Remove the drawer from the roll-away
(refer to the drawer removal
instructions).
• Lift the chest onto the roll-away. Line
up the holes in the bottom of the chest
with the holes in the top of the roll-
away.
RISER ASSEMBLY:
NOTE: When assembled, the riser
should be the same size, left to right, as
the chest. Use adequate manpower for
this operation.
• Assemble the sides and the back
(flange side up) together using four 8-
32 x 1/4 pan head screws and four 8-
32 hex nuts. Finger tighten.
• Position the riser assembly on the
roll-away. Secure using four 10-16 x
1/2 sheet metal screws. Wrench
tighten.
• Position the chest on the riser.
Secure using four 10-16 x 1/2 sheet
metal screws. Wrench tighten.
• Wrench tighten the risers four 8-32 x
1/4 pan head screws and 8-32 hex
nuts.
NOTE: Not all instructions apply to
your specific unit.
REMOVE CHEST FROM ROLL-
AW AY:
• The unit comes with the chest secured
to the inside of the roll-away by either
two or four 1/4-20 bolts.
• Lay the roll-away down on its back.
Use packaging material to protect the
paint finish.
• Remove the securing bolts from the
underside of the roll-away. Save the
screws for mounting the chest to the
roll-away.
• Remove the chest.
\\\
\
• Attach the chest using two 1/4-20
screws that were used to secure the
chest to the bottom of the roll-away.
• Wrench tighten all screws.
• Replace the drawer (refer to the
drawer installation instructions).
• To remove the chest, reverse the
procedure.
Back
Side
3 4
To Next Page
Loading...
Need help?
General
