Creality BLTouch User Manual

Circuit Wiring
⑤
Platform Adjustment
⑥
Install BLTouch
④
Software Settings
⑦
1、Insert connectors into 5 Pin
Port.
2、Install BLTocuh on the rack with
2 M3X6 screws
3、Rotate the knob until the distance between them is about 0.2mm（as a sheet of A4 paper），write down the value of A（For example, figure 3）
.
１、Ｏpen Cura
２、Settings→ Printer-Ｍanage
Printers
３、Machine Settings ４、Change "G28" to "G28 X0 Y0 G29 Z0"
4、Control→Motion→Z Offset→write down the value of B，then rotate the knob until it comes out as: C=B+A. Return Control and Select Store
settings.
3、Loosen all fan cover screws,
Install the farme on the
corresponding position with 2
M3X8 screws
4、Secure the cable to the guide tube
and cable with a cable tie and bypass
the rear side of the gantry.
0.2mm
A4 paper
1
2
3
4
1、Unplug the screen cable, connect
the pinboard A to the screen port
(EXP1).
2、Insert the screen cable into 10
pins port.
3、insert the connectors to the 3
pins port as the sign shows.
4、Unplug the Z limit switch(Z-stop
port),and insert the connectors.
1、Prepare→Auto home，and wait until it stops.
2、Prepare→Move axis→Move Z→Move 0.1mm→Rotate the knob until the distance between them is about 0.2mm（as a sheet of A4 paper），write
down the value of A.
B
C
A
figure 3
Screen

Creality BLTouch Specifications

General

Brand	Creality
Model	BLTouch
Category	Accessories
Language	English