Product overview
Enjoy audio from Bluetooth devices
b. Establish Bluetooth Connection
Press and hold the Bluetooth button
and release when the LED starts
blinking rapidly.
Power on the speaker by turning the
volume dial in the clockwise direction.
The LED status indicator will lit steady
indicating the speaker is currently ON.
Speaker Status
Pairing Mode
LED Status
LED rapid blinking
Powered ON (Idle) or
connected to any
Bluetooth
®
devices
Lit steady
a.
c. On Bluetooth device
. Turn ON the Bluetooth feature on your dev ce.
. Search for Creat ve T3250W.
. Pa r and connect to Creatve T3250W. If prompted for passcode, enter 0000.
v. Pa rng successfu , ready to stream musc.
Note: The above are generic steps to pair
to a Bluetooth device, for more
specific instructions on Bluetooth
connectivity for your device, please
consult your manufacturer’s
manual.
d. Ready to stream music via Bluetooth
®
Turn volume dial clockwise or
anti-clockwise to increase or decrease
volume. You may also adjust your
source device volume settings to
increase or decrease volume.
Bluetooth
Network
Connections
Operator
Internet
USB
ON
Connect vityConnectivity
Search results
Creative T3250W
Creative T3250W
PASSCODE
0000
CONNECTED
ii.i. ii. iv.
Creat ve T3250W
6
7
5
4
1
3
2
1
1
Pairing
1 LED status indicator
2 ON / OFF Switch / Volume
3 Bluetooth Connect button
4 To Wall Outlet
5 3 5mm analog stereo mini plug
6 Left speaker
7 Right speaker
Creative T3250 Wireless
Quick Start Guide
You can reconnect your paired Bluetooth device to your speaker easily.
Select ‘Creative T3250W’ entry on the Bluetooth device to reconnect any of the 4 previously
connected Bluetooth devices would be able to reconnect to Creative T3250W when the
T3250 Wireless is powered ON and not connected to any device.
The speaker enters power saving mode when there is no Bluetooth connection
or no audio signal detected on the Line-In connection for more than 15 minutes.
It is recommended to power off when the speaker is expected to be unused for
several days.
Note:
he Creative 3250 Wireless is able to remember up to 4 paired devices in its memory bank, eliminating
the need to re-pair again should any o these devices connect to the Creative 3250W Should a 5th
device be paired to the 3250W, the 1st device will be erased rom the 3250W s memory banks At any
one time a maximum memory o 4 devices are being retained
Reconnections between
Bluetooth device and
Creative T3250W
2
2
Power Saving Mode
3
3
Need help?
General
