ADJUSTING
AND OPERATING
V-BEL T
Main Drive Belt-(44-inch and 50-inch mowers)
1. Front cover2.
Idler ratchet3.
V -belt tension bolt
The
main drive V-belt is properly tensioned whenthe
idler ratchet is positioned as shown on the
decal on the front cover of the lift frame.
NOTE: When installing
the condition of the pull!
satisfactory condition, I
pulleys available at youl
dealer.
To adjust the belt for proper tension tighten the
V-belt tension bolt so the notch on the idler
ratchet is in line with the slot on the cover as
shown in the illustration.
To install or remove the belt, disengage the idler
ratchet to take the tension off the belt. Readjust
the V-belt tension as previously described.
NOTE: After the first half hour of mowing, check
the belt for proper tension.
53
a
new belt always check
~ys and if they are not inreplace
them with newr
I nternational Harvester
To Next Page
Loading...
Need help?
General
