Cub Cadet 1782 User Manual

R. S EAT ADJUSTMENT LEVER
The seat adjustment lever is used to move the seat
forward or rearward. Refer to ADJUSTING THE
SEAT in Section III.
single brake pedal is in the depressed position it
automatically moves the speed control lever to the "N"
position. (See Figure 9.)
S. S INGLE PEDAL BRAKE LOCK
A WARNING
The hydrostatic transmission will not hold
the tractor on a hill. In a short period of time
(depending on the steepness of the hill) the
oil will drain from the transmission and allow
the tractor to roll downhill. To avoid an
accident and/or possible injury, engage the
single pedal brake lock.
U. H YDRAULIC LIFT CONTROL LEVER
NOTE
The engine must be running in order to
operate the hydraulic lift.
The hydraulic lift control lever controls the raising and
lowering of equipment used with the tractor, if
installed. The control lever is spring loaded. To raise
the equipment pull up the lever. To lower the equip¬
ment, push down on the lever. (See Figure 10.)
Always engage the single pedal brake lock when
dismounting the tractor. To lock the brake, the turning
brake pedals must be locked together to provide brak¬
ing to both rear wheels. Refer to TURNING BRAKE
LOCK." Depress single brake pedal and place the sin¬
gle pedal brake lock in the engaged position. (See
Figure 9.) To disengage the lock, press down on the
pedal, lift the lock up and place it in the disengaged
position.
1. Single Brake Pedal
2. Single Pedal Brake Lock
T. S INGLE BRAKE PEDAL
V. T HROTTLE CONTROL LEVER
This lever controls the speed of the engine. When set
in a given position, it will maintain a uniform engine
speed. (See Figure 10.)
note
When using power take-off operated equip¬
ment, best performance is achieved with the
throttle lever in the "FAST’ position.
NOTE
Do not rest your foot on the single brake
pedal while driving the tractor as this would
cause the speed control lever to return to the
"N” position.
The single brake pedal must be pressed all the way
down to activate the safety starting switch. When the
This symbol shows slow position.
This symbol shows fast position.
W. F RONT POWER TAKE-OFF (PTO) CONTROL
SWITCH
The power take-off (PTO) control switch, which is
located on the left side of the instrument panel,
11

Cub Cadet 1782 Specifications

General

Brand	Cub Cadet
Model	1782
Category	Lawn Mower
Language	English