10 Section 2 — ASSembly & Set-Up
Unfolding the Handle
1. Remove the star knobs and carriage screws from the lower
handle. See Figure 3-3.
Figure 3-3
2. Pivot the upper handle into operating position. Be careful
not to crimp cables. See Figure 3-4.
Figure 3-4
3. Reinstall the carriage screws and knobs removed earlier.
4. Tighten the upper and lower star knobs and carriage
screws to secure the upper handle to the lower handle. See
Figure 3-4.
5. The handle height can be adjusted to any of three
positions. For instructions, refer to Handle Height in the
Maintenance and Adjustments section of this manual.
Attaching the Shift Lever
1. Remove the screw and the lock nut that secures the shift
lever to the shift lever plate. See Figure 3-5.
Figure 3-5
2. Remove the remaining screw and nut from the lower shift
lever plate. See Figure 3-5.
3. Position the upper shift lever into a vertical position
aligning the holes in the lever with the holes in the shift
plate. See Figure 3-6.
Figure 3-6
4. Secure the lever to the plate using the two screws and two
nuts removed earlier. See Figure 3-6 inset.
To Next Page
Loading...
Need help?
General
