General
Information
1‐33
Preparing the UV for
Storage
The amount of preparation a UV should
undergo before storage depends on the
expected length of non-use, storage
area conditions and personal
preference.
Consider the following list the minimum
requirement:
1.
Wash the UV thoroughly. Make
sure all dirt, mud and other
debris is removed.
2.
Start the engine and allow it to
reach operating temperature.
Drain the engine oil regardless
of the riding time since the last
service. Fill the engine with the
recommended type of oil.
3.
Drain the fuel tank, fuel lines and
carburetor, if equipped.
4.
Remove the spark plug and
ground the ignition system with a
grounding tool as described in
this chapter. Then pour a
teaspoon (15-20ml) of engine oil
into the cylinder. Place a rag
over the opening and turn the
engine over to distribute the oil.
Remove the grounding tool and
reinstall the spark plug.
5.
When the engine has cooled to
room temperature, drain the
cooling system. Drain the
coolant
in the coolant reserve
tank and
all tank lines.
6.
Cover the exhaust and intake
opening.
7.
Apply a protective substance to
the plastic and rubber
components. Make sure to follow
the manufacturer’s instructions
for each type of product being
used.
8.
Place the UV on work stands
with all the wheels off the
ground.
9.
Cover the UV with old bedsheets
or something similar. Do not
cover it with plastic material that
will trap moisture.
Returning the UV to
Service
The amount of service required when
returning a UV to service after storage
depends on the length of non-use and
storage conditions.
Note the following:
1.
Remove the covers from the
intake and exhaust openings.
2.
Service the air filter as described
in Chapter Three.
3.
Inspect the cooling system.
Check the drain plug and hose
connections for leaks.
4.
Refill the fuel tank. Turn the fuel
shutoff valve on and check for
fuel leaks.
5.
Make sure the brakes, clutch,
throttle and engine stop switch
work properly before operating
the UV. Evaluate the service
intervals to determine which
areas require service.
6.
If the UV has been in storage for
longer than four months, change
the engine oil and filter.
To Next Page
Loading...
Need help?
General
