Insert the depth stake into the depth gage bracket 4.
assembly as seen in Fig. 3–7.
Secure the pin with the clip removed earlier. The depth 5.
stake can be placed at various positions. For setup
purposes it is suggested that the depth stake be assembled
with the stake just above or level with the ground surface.
For further instructions on the Depth Stake refer to the
Maintenance & Adjustments Section of this manual.
Adjustments
Wheels
The tiller is shipped with the wheels adjusted so that the
machine sits level. The wheels need to be adjusted to meet
your tilling needs before operation. This adjustment is made
by removing the clevis pin from the wheel yoke and raising the
wheels to the desired height. See Fig. 3-8.
Set-Up
Gas & Oil Fill-Up
Service the Engine with gasoline and oil as instructed in the
separate Engine Operator’s Manual packed with your tiller. Read
the instructions carefully.
WARNING! Use extreme care when handling
gasoline. Gasoline is extremely flammable and the
vapors are explosive. Never fuel the machine
indoors or while the engine is hot or running.
Figure 3-7
Clevis
Pin
Cotter
Pin
Wheel Yoke
Depth
Stake
Figure 3-8
9se c t i O n 3 — as s e M b l y & se t -up
To Next Page
Loading...
Need help?
General
