Cub Cadet Series 3000 User Manual

8
J)
Discard both hydraulic
hoses for the hydraulic lift
cylinder provided with the
3 Point Hitch Attachment
and replace with the two
hydraulic hoses (E) (G)
provided in this service
kit. Place an O-Ring (D)
and backup O-Ring (C)
onto each hose ends.
Install the ends of the two
hydraulic hoses (E) (G)
into the ports of the fourth
valve located in front of
the center lift valve. See
Figure 9.
NOTE: For hose routing, refer
to the installation instruction
in the Owner’s Manual for the
3 Point Hitch Attachment.
FIGURE 9
K)
Remove and retain the lift lever cover/cup holder and flap from the fender. Take the template
label (L) from the service kit and position it on the fender as described on the label. Fasten
the template label (L) to the fender and mark the hole location as instructed on the label. See
Figure 10. Carefully cut out the hole in the fender using the most convenient method
available to you (ie sabre saw, hole saw, etc.). Discard the template and remove any sharp
edges. Touch up the paint finish to prevent rusting. See Figure 11.
FIGURE 10 FIGURE 11
L)
Take the push-on trim strip (H) from the service kit and position the strip around the new
hole in the fender. Press into place as shown in figure 12 and remove any excess material as
needed.
Hydraulic Hoses 3 point

Cub Cadet Series 3000 Specifications

General

Brand	Cub Cadet
Model	Series 3000
Category	Tractor
Language	English