Quick Installation Guide
Model: POE40
For support and warranty, please visit: http://www.cudy.com/.
Specifications are subject to change without notice. Cudy is a
registered trademark of Shenzhen Cudy Technology Co., Ltd.
Other brands and product names are trademarks or registered
trademarks of their respective holders.Copyright©2022 Shenzhen
Cudy Technology Co., Ltd. All rights reserved.
EU declaration of conformity
Cudy hereby declares that the device is in compliance with the
essential requirements and other relevant provisions of directives
2014/30/EU, 2014/35/EU, 2015/863/EU, 2009/125/EC and
2011/65/EU. The original EU declaration of conformity can be
found at http://www.cudy.com/ce
810600153
CE Mark Warning
This is a class B product. In a domestic environment, this product
may cause radio interference, in which case the user may be
required to take adequate measures.
Environment
Regulatory Compliance
Operating Temperature
Operating Humidity
Storage Temperature
Storage Humidity
Indoor
IEEE 802.3af (15.4W)
IEEE 802.3at (30W)
IEEE802.3bt 4Pairs (60W)
0 to 40℃
Maximum 90%, Non-condensing
-40 to 60℃
Maximum 95%, Non-condensing
Model
Data Speed
Connectors
Network cables
Dimensions
Mounting
POE40
10/100/1000 Mbps half/full duplex
Specifications
4
Pin Assignment and Polarity:
Both 1/2, 3/6 and 4/5, 7/8
Pin Assignment and Polarity:
1/2 (+), 3/6 (-)
Output Power: Up to 12W for 4 PSE
or MAX 30W for 2 PSE
Power indicator: PoE enabled
Powered success: Power
Network indicator: Link/Act
Power over Ethernet
input
Power over Ethernet
Output
Indicator
Shielded RJ-45, EIA 568A and 568B
Shielded category 5 (or higher)
119mm x 85mm x 28mm
Wall or shelf
Email:
support@cudy.com
Website:
www.cudy.com
To Next Page
Need help?
General
