English • Deutsch • Español • Français • Italiano • ??? • Polski • Português • ??????? • Svenska •
???(????)? • ???(??)? •
= D-Link DIR-300 Rev.A = Airlink101 AR430W = Airlink101 AR335W
Contents
1 Initial flashing instruction
1.1 Install RedBoot♦
1.2 Install DD-WRT♦
1.3 Recovery and
Upgrade
♦
1.4 Redboot access
script for Windows
♦
1.5 Redboot access
script for Linux
1.5.1 Putty◊
1.5.2 Telnet◊
♦
•
2 Hardware
2.1 Serial port♦
•
3 Overclocking•
Initial flashing instruction
Warning: Procedure below is valid only for DIR-300 Revision A. Please check carefully the revision
level of your D-Link before flashing
Don't use Builds 21676 - 23503 as it has a restart loop.
See Where do I download firmware? for links.
Windows flashing instruction for the D-Link DIR-300 to DD-WRT (by Brainslayer, modified by Sash,
v24_SP1 specific added by Deepak)
Install RedBoot
configure your local ip to 192.168.20.80 connect your lan cable to the WAN port of the router. plugoff the
power cord and replug it. You must press the RESET key for 5 sec. now enter the redboot using telnet and ip
192.168.20.81 and port 9000. connect your lan cable to the dir300 wan port. you might need several tries
since its only available for 1 second after aprox. 5 sec. of booting (below is a Windows & Linux access script
for an easy way to connect to redboot)
When you succeed you will be rewarded with a RedBoot> prompt.
DIR-300 Info:
IP: 192.168.20.81/255.255.255.0, Gateway: 0.0.0.0
D-Link_DIR-300_rev_A
Initial flashing instruction 1
To Next Page
Need help?
General
