ENGLISH
5V
RESET
1A
INTERNET12LAN34
5V
RESET
1A
INTERNET12LAN34
DIR-803
If any of the above items are missing, please contact your reseller.
DIR-803 Wireless AC750 Dual Band Router
Power Adapter
Ethernet Cable
Quick Install Guide
Wi-Fi Conguration Card
1 Power LED
A solid green light indicates a proper connection to the
power supply.
2 Internet LED
A solid green light indicates a proper connection to
your broadband modem. The light will blink during data
transmission.
3 WPS LED The light will blink during the WPS process.
4 Wireless LED
A solid green light indicates that the wireless segment is
ready. The light will blink during data transmission.
5 LAN LEDs (1-4)
A solid green light indicates a connection to an Ethernet
device. The LED will blink during data transmission.
6 WPS Button Press to start the WPS process. The WPS LED will start to blink.
7 LAN Ports (1-4)
Connect Ethernet devices such as computers, switches,
and game consoles.
8 Internet Port
Connect your broadband modem to this port using an
Ethernet cable.
9 Power Port Connect the supplied power adapter.
10 Reset Button
Press and hold the reset button with a paper clip for six
seconds to reset the router to the factory default settings.
1 3 5 7 8 9
1
Unplug the power to your DSL or Cable modem.
2
Connect an Ethernet cable from the yellow Internet port of the router to the
Ethernet port on your DSL or Cable modem.
3
Connect another Ethernet cable from the Ethernet port on your computer
to one of the LAN ports on the router.
4
Plug the power back into your DSL or cable modem. Please wait about one
minute before continuing.
5
Plug the power adapter into your router and connect to an available power
outlet or surge protector.
Modem
DIR-803
Computer
Modem
DIR-803
Computer
Package Contents
Hardware Overview Minimum Requirements Connect your Router
5V
RESET
1A
INTERNET12LAN34
6
After the router has powered up, verify that the Power and Internet LEDs are
both lit then continue with the Conguration section on the other side.
Modem
DIR-803
Computer
Ethernet Cable
• Users with DSL providers - If you are using a PPPoE connection, you will need
your PPPoE user name and password. If you do not have this information, contact
your Internet provider. Do not proceed until you have this information.
• Users with Cable providers - Make sure you unplug the power to your modem.
In some cases, you may need to turn it o for up to 5 minutes.
• Advanced Users - If your ISP provided you with a modem/router combo, you will
need to set it to “bridge” mode so the DIR-803 router can work properly. Please
contact your ISP or refer to the user manual for your modem/router device.
Before you Start
Network Requirements:
• An Ethernet-based broadband modem
Web-based Conguration Requirements:
Computer with the following:
• Windows® or Mac OS® X operating system
• An installed Ethernet adapter or wireless adapter
Supported Browsers:
• Internet Explorer 7 or higher
• Safari 4 or higher
• Chrome
• Firefox
2
10
6
Wireless AC750
Dual Band Router
4
5V
RESET
1A
INTERNET12LAN34
Ethernet Port
Modem
DIR-803
Internet Port
To Next Page
Need help?
General
