DSL-2750U Wireless ADSL2+ Router with 3G/LTE/Ethernet WAN Support
and USB Port
User Manual
Installation and Connection
Connecting to Web-based Interface
When you have configured your computer, you can access the web-based interface and configure
needed parameters (create a WAN connection, change the parameters of the wireless network,
specify the settings of the firewall, etc.)
Start a web browser (see the Before You Begin section, page 15). In the address bar of the web
browser, enter the IP address of the router (by default, 192.168.1.1) or its domain name (by
default, dlinkrouter.local) with a dot at the end. Press the Enter key.
Figure 15. Connecting to the web-based interface of the DSL-2750U device.
!
If the error “ The page cannot be displayed ” (or “ Unable to display the page ”/“ Could not
connect to remote server ”) occurs upon connecting to the web-based interface of the router,
make sure that you have properly connected the router to your computer.
If the device has not been configured previously or the default settings have been restored, after
access to the web-based interface the Initial Configuration Wizard opens (see the Initial
Configuration Wizard section, page 37).
Figure 16. The page for running the Initial Configuration Wizard.
Page 30 of 210
To Next Page
Need help?
Data Transfer Rates
