25/9/08
ACTIVE DRIVER
INTRODUCTION
The DAB ACTIVE DRIVER is an innovative integrated pump control system that utilizes a
variable frequency drive controller (VFD) to provide CONSTANT PRESSUE regardless of the
demand flow requirements.
>Applications
The DAB ACTIVE DRIVER will fit to most DAB domestic pump, specifically Jet, JINOX, JECOM,
EURO, EUROINOX, EUROCOM, K Series and KVCX Vertical Multistage.
The unit is available if the following configurations,
ACTIVE DRIVER M/M 1.1
Suits single phase 230v power supply, and will couple to single phase pump units up to
1.1kW, and is programmable to a maximum pressure of 6 Bar (600kPa), not exceed a
flow of 300lpm.
ACTIVE DRIVER M/T 1.0
Suits single phase 230v power supply, and will couple to three phase pump units up to
1.0kW, and is programmable to a maximum pressure of 9 Bar (900kPa), not exceed a
flow of 300lpm.
ACTIVE DRIVER M/T 2.2
Suits single phase 230v power supply, and will couple to three phase pump units up to
2.2kW, and is programmable to a maximum pressure of 9 Bar (600kPa), not exceed a
flow of 300lpm.
INVERTER
CONTROLLED
To Next Page
Need help?
General
