DAB PUMPS reserves the right to make modifications without notice
To ensure the proper operation of the pump, it is important to comply with the following recommendations:
• The pump must never be allowed to run dry.
• Never leave the pump in operation when the delivery pipe is clogged.
• Place the pump in a vertical or horizontal position on a fat surface at the bottom of the pond.
Care should be taken not to seat the intake of the pump directly into mud or pond debris as this may cause the
strainer to initially block.
• The pump must only be used when it is immersed in water. If the water runs out, the pump must be stopped immediately
by removing the plug from the power supply.
• It is absolutely essential to prevent any risk of the pump freezing. In the event of freezing temperatures, remove the
pump from the liquid, empty it and keep it in a place where it cannot freeze.
• Check the pump installation regularly to ensure the base inlet is clear of debris and that water is fowing unrestricted
4. RECOMMENDATIONS
Occosionally it may be necessary to clean the water intake chamber.
Unscrew the four screws from bottom plate (pos 1) from the main body (pos. 2).
Thoroughly fush the inner cavity and impeller with clean water
Repfit the base taking care not to damage the o-ring
To Next Page
Loading...
Need help?
General
