12
FUNCTION
FAN MODE
Push the ‘MODE’ button until
‘FAN’ lamp lights.
ON/OFF ENERGY SAVE
Push the ‘ENERGY SAVE’
button.
TURBO MODE
Push the ‘MODE’ button until
‘TURBO’ lamp lights.
OFF TIMER
Push the ‘TIMER/CANCEL’
button when unit is working.
(REMOCON ONLY)
OPERATION
1. The Fan works only.
2. In this mode, the unit circulate room air.
3. Fan speed can be changed.
1. Desired temperature is changed as
follows by pushing ‘ENERGY SAVE’
button.
2. When the ‘ENERGY SAVE’ button is
pushed, the fan speed goes to ‘Low’
3. When the ‘ENERGY SAVE’ function
is canceled by pushing ‘ENERGY
SAVE’ button once again, the
desired temperature is return to the
former desired temperature.
1. Fan speed is set to ‘HIGH’ and
desired temperature to 18°C (64°F).
1. Timer is set to as follows by pushing
“TIMER/CANCEL” button.
(1hr→2hr→3hr→4hr→5hr→6hr→8hr→
10hr→12hr→16hr→20hr→24hr→cancel)
2. Unit is off after timer is over.
3. If you want to cancel timer, push this
button again at any time.
DISPLAY
1. Current room temperature is
displayed.
2. ‘FAN’ lamp lights.
3. ‘ROOM TEMP’ lamp lights.
1. Current room temperature is
displayed.
2. ‘ENERGY SAVE’ lamp lights.
3. ‘ROOM TEMP’ lamp lights.
1. Current room temperature is
displayed.
2. ‘TURBO’ lamp lights.
3. ‘ROOM TEMP’ lamp lights.
1. ‘TIMER’ lamp lights.
2. Set time is displayed.
3. After a few seconds, display is
changed to current room temprature.
and ‘ROOM TEMP’ lamp lights.
To Next Page
Loading...
Need help?
General
