AK-PC 781 Version 4.1x Menu operation RC8CE202 © Danfoss 03/2013 3
Go through the individual functions one by one and make the required settings. When settings have
been made for one controller, the set values may be used as basis in the other controllers of the same
type and with the same software version. Copy the settings by using the copy settings function in the
AKM programme, and adjust subsequently any settings where there are deviations.
NB! If a list is required for noting down the individual settings, a printout can be made of it with a func-
tion in the AKM programme. Read the next section, “Documentation”.
Documentation Documentation of the settings of the individual controllers can be made with the print function in the
AKM programme. Select the controller for which documentation of the settings is required and select
the “Print Settings” function (cf. also the AKM Manual).
Functions Shown below are function groups with corresponding measurements and settings. A printout of the
given settings can be made using the AKM function “Print Settings” (see above).
Note It has been necessary to make selections among the many measurements and settings coming from
the controller.
The operation from the AKM programme cannot contain them all.
If there is a need for access to all measurements and settings, you should make use of Service Tool
type AK-ST 500.
To Next Page
Loading...
Need help?
General
