Danfoss HC6110-3 User Manual

9
This feature allows the installer to
select a timed fan overrun following
each cooling demand. The unit is
pre-set to o . Using the + or - buttons
select your preference from o , 30,
60 or 90 seconds.
Press the PROG button to advance to
the next setting option.
Setting Fan Run-On After Cooling (option 3)
or
+
-
This feature allows the installer or
the building owner to determine
the minimum deadband between
heating and cooling. The unit is pre-
set to 2°C. Using the + or - buttons
select your preference from 1°C, 2°C,
3°C or 4°C.
Press the PROG button to advance to
the next setting option.
Setting Heating/Cooling Deadband (option 4)
or
+
-
Installation Instructions
GB

Danfoss HC6110-3 Specifications

General

Brand	Danfoss
Model	HC6110-3
Category	Thermostat
Language	English