Quick Start Guide
ICM/ICAD Motorized Valves
Installation, Programming, and Troubleshooting
© Danfoss | DCS (MWA) | 2016.07
DKRCI.EI.HT0.B3.22 | 520H4763 | 1
The ICM motorized valve is comprised of up to 4
components:
• the valve body – often referred to as the ICV body
because it is used for ICM motor valves, ICS pilot
operated valves and ICLX solenoid valves.
• the function module – the ow regulating part of
the valve
• the top cover – on the ICM 20 through 65, the
function module and top cover are one part
• the ICAD motor actuator – the “brains” of the
valve
Actuator ICAD 600A ICAD 1200A Old ICAD 600* Old ICAD 900* Old ICAD 1200*
Valve Size ICM 20 ICM 40 ICM 20 ICM 40 ICM 40
Valve Size ICM 25 ICM 50 ICM 25 ICM 50 ICM 50
Valve Size ICM 32 ICM 65 ICM 32 ICM 65 ICM 65
Valve Size ICM 100 ICM 100
Valve Size ICM 125 ICM 125
Valve Size ICM 150 ICM 150
ICM/ICAD overview The combinations of valve and actuator are as follows:
* ICAD 600, 900 and 1200 were discontinued at the end of 2014. ICAD 600A is a direct replacement of ICAD 600 and ICAD 1200A is a
direct replacement of ICAD 900 or ICAD 1200.
To Next Page
Need help?
General
