Danfoss VLT 5022 Operating Instructions

VLT
®
5000 Series
This parameter initialises all except:
500 Serial communication address
501 Baud rate for serial communication
601-605 Operating data
615-617 Fault logs
Manual initialisation
• Disconnect from mains and wait until the
display turns off.
• Press the following keys at the same time:
[Display/status]
[Change data]
[OK]
• Reconnecting the mains supply while
pressing the keys.
• Release the keys
• The frequency converter has now been
programmed for the factory setting
.
This parameter initialises all except:
600-605 Operating data
NB!:
Settings for serial communication and
fault logs are reset.
MG.51.A9.02 - VLT is a registered Danfoss trademark
72

Danfoss VLT 5022 Specifications

General

Brand	Danfoss
Model	VLT 5022
Category	DC Drives
Language	English