VLT
®
5000 Series
Miscellaneous
Start not possible (START INHIBIT):
The drive is in fieldbus profile mode. OFF1, OFF2 or
OFF3 have been activated. OFF1 must be toggled
to be able to start (OFF1 set from 1 to 0 to 1).
Not ready for operation (UNIT NOT READY):
The drive is in Fieldbus profile mode (parameter
512). The drive is not ready for operation as bit
00, 01 or 02 in the control word is "0", the drive
has tripped or there is no mains supply (only seen
on units with 24 V DC supply).
Ready for operation (CONTROL READY):
The drive is ready for operation. For extended units
supplied with a 24 V DC supply the message also
comes up when there is not mains supply.
Bus jog, remote controlled (REM/RUN BUS JOG1):
Remote control has been selected in parameter 002
and the Fieldbus has been selected in parameter 512.
Bus Jog has been selected by the fieldbus or serial bus.
Bus jog, remote controlled (REM/RUN BUS JOG2):
Remote control has been selected in parameter 002
and Fieldbus has been selected in parameter 512. Bus
Jog has been selected by the fieldbus or serial bus.
MG.51.A9.02 - VLT is a registered Danfoss trademark
167
To Next Page
Loading...
Need help?
General
