Use To
Enable Manual Fax
On
Off
Set the printer to fax manually, which requires a line splitter and a telephone handset.
Notes:
• Off is the factory default setting.
• Use a regular telephone to answer an incoming fax job and to dial a fax
number.
• Touch # 0 on the numeric keypad to go directly to the Manual Fax function.
Memory Use
All receive
Mostly receive
Equal
Mostly send
All send
Define the allocation of non-volatile memory between sending and receiving fax jobs.
Notes:
• “Equal” is the factory default setting. This splits the memory for sending and
receiving fax jobs into equal amounts.
• “Mostly send” specifies that most of the memory is set to send fax jobs.
• “All send” specifies that all the memory is set to send fax jobs.
• “All receive” specifies that all the memory is set to receive fax jobs.
• “Mostly receive” specifies that most of the memory is set to receive fax jobs.
Cancel Faxes
Allow
Don't Allow
Specify whether or not the printer cancels fax jobs.
Note: Allow is the factory default setting.
Caller ID
Off
Primary
Alternate
Specify the type of caller ID being used.
Fax number masking
Off
From left
From right
Specify the direction from where digits are masked in an outgoing fax number.
Notes:
• Off is the factory default setting.
• The number of characters masked is determined by the “Digits to mask”
setting.
Digits to Mask
0–58
Specify the number of digits to mask in an outgoing fax number.
Note: 0 is the factory default setting.
Understanding the printer menus 173
To Next Page
Loading...
Need help?
General
Weight and Dimensions
