Upgrade Dell EMC Networking N3000E-ON Switches
Page 4
4. Activate the 6.5.3.36 firmware
console#boot system backup
Activating image backup ..
5. Reload the switch.
console#reload
Management switch has unsaved changes.
Are you sure you want to continue? (y/n) y
Configuration Not Saved!
Are you sure you want to reload the stack? (y/n) y
6. After the switch has finished rebooting, log in and verify that the firmware has been updated to the 6.5.3.36
version using the show version command. A single switch will typically reboot in around two minutes. A
stack may take significantly longer to complete the upgrade process.
console#show version
Machine Description............... Dell EMC Networking Switch
System Model ID................... N3048EP-ON
Machine Type...................... Dell EMC Networking N3048EP-ON
Serial Number.....................
Manufacturer...................... 0xbc00
Burned In MAC Address............. 0090.BC06.A571
System Object ID.................. 1.3.6.1.4.1.674.10895.3060
SOC Version....................... BCM56340_A0
HW Version........................ 5
CPLD Version...................... 20
Image File........................ N3000Advv6.5.3.36
Software Capability............... Stack Limit = 12, VLAN Limit = 4093
unit active backup current-active next-active
---- ----------- ----------- -------------- --------------
1 6.5.3.36 6.5.3.36 6.5.3.36 6.5.3.36
7. The switch or stack is now ready for normal operation. Verify the configuration and make any changes
needed prior to connecting the switch to the operational network.
8. Reload the switch.
console#reload
Management switch has unsaved changes.
Are you sure you want to continue? (y/n) y
Configuration Not Saved!
Are you sure you want to reload the stack? (y/n) y
To Next Page
Loading...
Need help?
General