Layer 3 Routing Commands 1618
show ipv6 pim rp-hash
Use the show ipv6 pim rp-hash command to display which rendezvous point
(RP) is being selected for a specified group.
Syntax
show ipv6 pim rp-hash group-address
group-address
— Group IP address supported by RP.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
There are no user guidelines for this command.
Example
console#show ipv6 pim rp-hash ff1e::/64
RP Type
Address
------------------------ -----
3001::1 BSR
show ipv6 pim rp mapping
Use the show ipv6 pim rp mapping command to display all group-to-RP
mappings of which the router is aware (either configured or learned from the
bootstrap router (BSR). If no RP is specified, all active RPs are displayed
Syntax
show ipv6 pim rp mapping [ rp-address | candidate | static ]
• rp-address — IP address of RP.
• candidate—Show candidate rendezvous point mappings.
To Next Page
Loading...
Need help?
General
